Enables the link aggregation control protocol (LACP) globally.
Config mode
This command is available only to users with the admin role.
After enabling LACP globally, there is no need to run LACP on all LAGs on the switch. You can
enable LACP on each channel mode using the channel-group mode
command.
The no feature lacp command disables LACP globally.
The following example enables LACP globally.
device# configure terminal device(config)# protocol lacp device# show running-configuration protocol lacp hardware connector 1/8 breakout 4x10g connector 2/8 breakout 4x10g interface ethernet 1/1 shutdown